top of page

SERVICES

Rebar Threading & Couplers
Cut & Bend 
Galvanised Coupler
43708914_350921125654903_701367450337699
31241804_10216374488374449_8070609317188
43648577_2176133089332965_54382367077176
43661924_1958721984427302_43413987786877
D-Wall Area 
FW Coupler System : Break @Rebar Area 
43542673_304974463618550_566136324374711
36223158_10216911475958803_5748357097657
FAIRWAY Coupler System Dimensions 
32
60
25
90
FAIRWAY Mechanical Coupler System 
1-page-001.jpg
28
40
32
50
70
60
48
40
30

Rebar Size 

T13

T16

T20

T25

T32

T40

Diameter (mm)

Length (mm) 

Fairway Mechnical Coupler System is designed and manufacture to the highest quality requirements and is using the best parallel thread system. 

Specifically designed for the splicing of reinforcement bar sizes ranging from 13 mm up to 50 mm.

 

Strength: The coupler after splicing is greater than the reinforcement bar and it does not depend on surrounding concrete for transfer of loads.   

Fairway Coupler passes the ISO9001:2015. It is in compliance with and satisfy the following code: 

Types of FW Mechanical Coupler 

Type 1 (Standard) 

1. Cut and remove the plastic cap on the threaded rebar and place the threaded rebar into the end of coupler. 

2-page-001.jpg

2. Rotate the rebar by hand to join both ends together. 

2-page-001.jpg

Type 2 (Position) 

1. Fully engage the coupler into the extended thread 

2-page-001.jpg

2. Turn the coupler from extended thread towards the standard thread until it's fully engaged. 

2-page-001.jpg
bottom of page